158
Child safety
E3_en_Chap08_securite_enfants_ed01-2014
Locations for i-Size child seats
The i-Size child seats have two latches that engage on the two rings A.
Refer to the "ISOFIX mountings" section.
i-U: seat suitable for i-Size restraints of the "universal" category,
forward facing or rearward facing.
Remove and stow the head restraint before installing a child seat on a passenger seat.
Refit the head restraint once the child seat has been removed.
(a) to install a child seat at the rear, rearward facing or forward facing,
move the front seat forward, then straighten the backrest to allow
enough space for the child seat and the child's legs.
The i-Size child seats also have:
- either an upper strap which is attached to the ring B (see the "ISOFIX mountings" section).
- or a support leg which sits on the vehicle's floor, compatible with seat approved for i-Size, the role of which is to prevent the child seat from tipping
forwards in the event of a collision.
In accordance with the new European Regulations, this table indicates the options for installing i-Size child seats on seats in the vehicle fitted with
ISOFIX mountings and approved for i-Size.
i-Size child seat
1
st
row Front passenger seat Not i-Size
2
nd
row
Outer rear seats (a) i-U
Centre rear seat Not i-Size
To Next Page
Loading...
