180
Practical information
E3_en_Chap09_info_pratiques_ed01-2014
Checking tyre pressures /
inflating accessories
You can also use the compressor, without
injecting any product, to:
- check or adjust the pressure of your tyres,
- inflate other accessories (balls, bicycle
tyres...).
F Turn the selector A to the "Air"
position.
F Uncoil the black pipe H fully.
F Connect the compressor's electrical
connector to the vehicle's 12 V socket.
F Start the vehicle and let the engine run.
F Adjust the pressure using the compressor
(to inflate: switch B in position "I"; to
deflate: switch B in position "O" and press
button C), according to the vehicle's tyre
pressure label or the accessory's pressure
label.
F Remove the kit then stow it.
Should the pressure of one or more
tyres be adjusted, it is necessary to
reinitialise the under-inflation detection
system.
Refer to the "Under-inflation detection"
section.
F Connect the black pipe to the valve of the
wheel or accessory.
If necessary, fit one of the adaptors
supplied with the kit first.
To Next Page
Loading...
