182
Practical information
E3_en_Chap09_info_pratiques_ed01-2014
F Unclip the tool storage box by pulling on it.
The spare wheel is installed in the boot under
the floor.
Spare wheel (depending on version)
Taking out the wheel
F Unscrew the yellow central bolt.
F Raise the spare wheel towards you from
the rear.
F Take the wheel out of the boot.
Putting the wheel back in place
F Put the wheel back in its housing.
F Unscrew the yellow central bolt by a few
turns then put it in place in the centre of the
wheel.
F Tighten fully until the central bolt clicks to
retain the wheel correctly.
F Clip the tool storage box back into place.
To Next Page
Loading...
