99
5
Driving
E3_en_Chap05_conduite_ed01-2014
Switching on / Pause
F Turn wheel 1 to the "LIMIT" position: the
speed limiter mode is selected but is not
switched on (Pause).
F Switch the speed limiter back on by
pressing button 4, if the speed displayed
is suitable (by default, the last speed
programmed).
F You can temporarily stop the the speed
limiter by pressing button 4 again: the
display confirms that it has been stopped
(Pause).
After first selecting speed limiter mode (wheel 1
in position "LIMIT"), you can modify the speed
setting by:
- a press on button 5:
F the six speeds memorised are displayed
in the touch screen tablet,
F choosing a speed: it is displayed in the
instrument panel.
The selection screen closes after a few
moments.
Speed limits can be memorised in the
"Driving assistance" menu.
For more information on the list of
memorised speeds, refer to the
"Memorising speeds" section.
You do not have to switch the speed
limiter on in order to set the speed.
The speed limiter is switched on
manually: it requires a programmed
speed of at least 20 mph (30 km/h).
Adjusting the speed limit
setting
Or:
- using buttons 2 and 3, increasing or
decreasing the speed displayed:
F by successive short presses, to modify
by + or - ½ mph (1 km/h),
F by a maintained press, to modify in steps
of + or - 3 mph (5 km/h).
To Next Page
Loading...
