P R A C T I C A L I N F O R M A T I O N
Connect the compressor's elec-
tric plug to the vehicle's 12 V
socket again.
Start the vehicle again and leave
the engine running.
Adjust the pressure using the
compressor (to infl ate: switch A
in position "1" ; to defl ate: switch
A in position "0" and press but-
ton B ), in accordance with the
vehicle's tyre pressure label (lo-
cated on the door aperture on the
driver's side), then remember to
check that the leak is fi lled cor-
rectly (no further loss of pressure
after several miles [kilometres]).
Remove the compressor, then
store the whole kit.
Drive at reduced speed (50 mph
[80 km/h] max) limiting the dis-
tance travelled to approximately
120 miles (200 km).
Visit a CITROËN dealer as soon as
possible to have the tyre repaired
or replaced by a technician.
Take care, the bottle of
puncture repair fl uid con-
tains ethylene-glycol. This
product is harmful if swallowed and
causes irritation to the eyes. Keep
it out of reach of children.
The expiry date of the fl uid is indi-
cated on the base of the bottle.
The bottle is designed for a sin-
gle use; even if only partly used, it
must be replaced.
After use, do not discard the bot-
tle into the environment, take it to a
CITROËN dealer or to an organisa-
tion responsible for its collection.
Do not forget to obtain a new bot-
tle of fi lling product, available from
CITROËN dealers.
If the vehicle is fi tted with tyre
under -infl ation detection, the tyre
under-infl ation warning light will
remain on after the wheel has been
repaired until the system is reini-
tialised by a CITROËN dealer.
To Next Page
Loading...
