C O M F O R T
Press button 3 several times
until the programme number
corresponding to the required
programme time is displayed.
The chosen pre-selected time
is activated automatically after
10 seconds if no other buttons
have been pressed.
To confi rm that the mode is activat-
ed, symbols 4 and 8 fl ash until the
heating starts up.
When the heating starts up, the
warning lamp 9 lights up on the
dashboard and the programmer
screen.
Press button 3 briefl y: the display
of the start-up time goes off.
In the event of a battery failure, the
factory settings are restored.
Stopping the heating system
while operating
Press button 5 .
The warning lamp 8 and the screen
go out.
When a programme is operating,
pressing button 2 or 7 displays the
heating start-up time. A second
press on these buttons displays the
time.
When a programme is not operat-
ing, pressing button 2 or 7 displays
the time.
When the heating is operating, the
remaining operating duration is dis-
played instead of the time.
● The pre-selected start-up time
can be modifi ed or cancelled by
following the instructions previ-
ously given above.
● In the event of a battery discon-
nection, the programmer must
be reset (hours, minutes etc.)
● As a secondary advantage, use
of your programmable heating
system allows it to be used to pre-
heat the passenger compartment.
Selection and activation of
the programmed heating
start-up time
Cancelling the current
programme
Reading the time
To Next Page
Loading...
