140
Driving
Activation/Deactivation
By default, the system is automatically
activated at every engine start.
The function is activated and
deactivated in the Driving/Vehicle
menu of the touch screen.
Displays in the instrument panel
1. Detected speed limit indication.
or
2. Indication of the end of the speed limit.
The system is active but is not detecting speed
limit information.
On detection of speed limit information, the
system displays the value.
Operating limits
The legislation on speed limits is specific to
each country.
The system does not take account of reduced
speed limits in the following cases:
- poor weather (rain, snow),
- atmospheric pollution,
- when towing,
- driving with a space-saver type spare wheel
or snow chains fitted,
- puncture repair using the temporary repair
kit,
- young drivers, etc.
The following situations may interfere with
the operation of the system or prevent it from
working:
- poor visibility (inadequate street lighting,
falling snow, rain, fog),
- windscreen area located in front of the
camera dirty, misted, frost-covered, snow-
covered, damaged or covered by a sticker,
- fault with the camera,
- obsolete or incorrect mapping,
- obstructed road signs (by other vehicles,
vegetation, snow),
- speed limit signs that do not conform to the
standard, are damaged or distorted.
Recommendation
For a suggested maximum speed, the first
time that the vehicle's speed exceeds it by
more than 3 mph (5 km/h) (example: 59 mph
(95 km/h)), the speed flashes for 10 seconds.
In addition to Speed Limit recognition and
recommendation, the driver can select the
speed displayed as a speed setting for the
speed limiter or cruise control using the speed
limiter or cruise control storage button.
To Next Page
Loading...
