212
In the event of a breakdown
Boot (W5W)
F Unclip the unit using a small flat blade
screwdriver.
F Remove the bulb and replace it.
F Put the unit back in place.
Changing a fuse
Access to the tools
The extraction tweezers are located behind the
dashboard fusebox cover.
F Unclip the cover by pulling at the top.
F Disengage the cover completely.
F Take the tweezers from their housing.
Replacing a fuse
Before replacing a fuse:
F the cause of the failure must be identified
and rectified,
F all electrical consumers must be switched
off,
F the vehicle must be immobilised with the
ignition off,
F identify the defective fuse using the
allocation tables and the diagrams on the
following pages.
To replace a fuse, you must:
F use the special tweezers to extract the fuse
from its housing and check the condition of
its filament.
F always replace the failed fuse with a fuse
of the same rating (same colour); using
a different rating could cause faults (risk of
fire).
If the fault recurs after replacing a fuse, have
the electrical system checked by a CITROËN
dealer or a qualified workshop.
Replacement with a fuse not shown in
the allocation tables below may cause
a serious malfunction of your vehicle.
Contact a CITROËN dealer or a qualified
workshop.
To Next Page
Loading...
