7
EtherNet/IP Connection Procedure
12
The Synchronization Dialog Box
is displayed.
Check that the data to transfer
(example: NX102) is selected.
Click Transfer To Controller.
*After executing "Transfer To
Controller", the Sysmac Studio
data is transferred to
Controller, and the data is
synchronized.
The dialog box on the right is
displayed. Confirm that there is
no problem, and click Yes.
A screen is displayed stating
"Synchronizing".
The dialog box on the right is
displayed. Confirm that there is
no problem, and click No.
*Do not return to RUN mode.
To Next Page
Loading...