CKD AX9000TS-U6 - CKD ABSODEX Driver Setup

7
．
EtherNet/IP Connection Procedure
14
7.2. CKD ABSODEX Driver Setup
Set up the CKD ABSODEX Driver.
7.2.1. Cable Connection
Connect the cables to the ABSODEX Driver.
Precautions for Correct Use
Before following the steps below, check the capacities of the main and control power supplies
and wire them by referring to the INSTRUCTION MANUALABSODEX AX SERIES TSTYPE
TH TYPE XS TYPE (SMF-2006-A).
Precautions for Correct Use
Make sure that the power supplies are all OFF before setting up.
If any of them are ON, the settings described in the following steps and subsequent
procedures may not be applicable.
1
Make sure that the following
power supplies are all OFF.
- Main and control power
supplies to ABSODEX Driver
- External power supply for
ABSODEX Driver
2
Check the position of the
connectors on ABSODEX Driver
by referring to the figure on the
right.
Main power
connector
Control
power
connector
Actuator
output terminal
RS-232C
connector
Resolver cable
connector
Safety function
terminal
EtherNet/IP
connector
Emergency stop
terminal
Brake terminal