7
EtherNet/IP Connection Procedure
7.4.2. Uploading the Network Configuration
Go online with Network Configurator and upload the network configuration.
Precautions for Correct Use
Make sure that the LAN cables are connected before performing the following steps.
If not, turn OFF the devices, and then connect the LAN cables.
1
Turn ON the following power
supplies.
- Switching hub power supply
- Main, control and external
power supplies to
ABSODEX Driver
Select Select Interface –
NJ/NX/NY Series Ethernet
Direct I/F from the Option
Menu.
*The procedures with Network
Configurator in this guide
assume the online connection
with
Built-in EtherNet/IP port
(PORT1)
on Controller via
3
Select Connect from the
Network Menu.
4
The Select Connect Network
Port Dialog Box is displayed.
Select Back Plane – 1 NX102
– TCP:2.
Click OK.
To Next Page
Loading...