7
EtherNet/IP Connection Procedure
9
The Target Device Dialog Box
is displayed.
Select 192.168.1.1 and
192.168.1.2.
Click OK.
*If 192.168.1.1 and
192.168.1.2 are not displayed
in the dialog box, click Add to
add the addresses.
*The display of addresses may
differ if any previously set
addresses are remained in
Network Configurator.
The parameters of the
connected devices are
uploaded.
After completing the upload,
the dialog box on the right is
displayed. Check the contents
and click
.
Check that the nodes with the
following IP addresses are
configured in the Network
Configuration Pane.
- Controller (Node 1)
IP address: 192.168.1.1
- ABSODEX Driver (Node 2)
To Next Page
Loading...