CKD AX9000TS-U6 - Page 46

7
．
EtherNet/IP Connection Procedure
43
3
The Edit Connection Dialog
Box is displayed.
Set the values (listed in the
following table) in the
Connection I/O Type,
Originator Device and Target
Device Fields.
Click Regist.
Editing settings for connections
Setting item Setting value
Connection I/O Type Exclusive Owner
Originator Device Input Tag Set EIP002_IN-[32 Byte]
Connection Type Point to Point connection
Output Tag Set EIP002_OUT-[32 Byte]
Connection Type Point to Point connection
Target Device
Output Tag Set
Input_101-[32 Byte]
Input Tag Set Output_102-[32 Byte]
4
The Edit Connection Dialog
Box is displayed again.
Click
Close
.
5
The Edit Device Parameters
Dialog Box is displayed.
Check that the connections set
for 192.168.1.2 are registered.
Click OK.