9
The new Cerio cutterbar has a fixed
length table like the previous C range of
CLAAS cutterbars. However, we now
have the ability to adjust the length of
the table manually.
With undoing only 10 bolts we are able
to extend and retract the table into 5
different positions. (tightening torque of
blolts is 50 nm)
1. 0mm
2. 50mm
3. 100mm
4. 150mm
5. 200mm
There are no extra shafts to be fitted,
unlike the old vario cutterbar. The shaft
extends and retracts fully across the full
movement of table.
VARIO ONLY
The new cutterbar has a park feature for
transport, this is marked by a sticker for
manual placement; however, this can be
done automatically. With only the engine
running and the multi coupler connected,
by pressing and holding the auto contour
button (1) the cutter bar will bring the
table, and reel, into parked position. Then
when you reconnect, press the pre-set
height button (2) and hold until 3 beeps
are heard, the cutterbar will then return to
its previously set auto settings.
Cutterbar
Adjustments
To Next Page
Loading...
