DSX SERVOTRONIC MPS
®
18
As soon as you open the hot water tap, the instantaneous water heater switches
on auto ma ti cally. When the tap is closed, the appliance automatically switches
off. The water heater is operated at the device itself or with the wireless remote
control.
Temperature setting
You can set the required temperature gradually to a lower or higher value with the
arrow keys and . The temperature changes by 1 °C, in the convenience zone
between 35 °C and 42 °C even by 0.5 °C, if key is pressed shortly one time. Pressing a
key for a longer time changes the temperature continuously. You can select the outlet
temperature from 20 °C to 60 °C. The display confirms the temperature changes by
“warmer” respectively “colder”.
Note: If temperature is set below 20 °C with arrow key the display shows “--“
and the appliance switches off the heating function.
Note: If the water heater supplies a shower and is connected to a remote control
system, the maximum temperature was reduced during initial operation. This
limitation cannot be exceeded.
Programme keys
The four programme keys at the device allow to quickly select the preset temperature.
The factory setting for application “hand wash” is 35 °C, for application “shower”
it is 38 °C, for application “bath tub” it is 42 °C, and for application “kitchen” it is
48 °C.
You can assign your own settings for the programme keys:
Select the desired temperature via the arrow keys and . Prolonged pressing (at
least 3 seconds) of one of the four programme keys stores the previously selected tem-
perature. The display confirms by “
--OK--
” and an acoustic signal will resound.
The stored temperature is now avai lable to you each time you press the corresponding
programme key.
Set temperature
1
–1 °C
+1 °C
35,0..42,0 °C Convenience zone
1
–0,5 °C
+0,5 °C
Select preset temperature
A1 A2
B1 B2
C1 C2
D1 D2
Store temperature
2
Press ≥ 3 sec
3
1
3. How to use
To Next Page
Loading...
Need help?
General
