EasyManuals Logo

clage DSX Operating Instructions For User

clage DSX
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #25 background imageLoading...
Page #25 background image
25
CLAGE
Mounting the wall bracket
Before attaching the wall bracket to the wall, ensure that the remote control
has radio contact to the instantaneous water heater from its designated posi-
tion.
The wall bracket of the remote control can either be attached securely with the
included adhesive tape, after stripping off the protection film (as shown in the fig-
ure A), on a rigid board (e.g. tile) or with suitable dowels (Ø 4 mm) and screws (as
shown in the figure B).
When using the adhesive tape it is not possible to further adjust the position
because of the strong adherence of the glue. Therefore, pay attention to a horizontal
alignment when attaching it.
The remote control is magnetically retained at the wall bracket.
4. Remote control
Figure B:
Optional installation with dowels and screws
Figure A:
Installation with adhesive tape
Initial operation
After inserting the batteries in the remote control its display indicates all symbols for
about 4seconds. By the time the power settings have been carried out, the remote
control indicates the current setpoint (factory setting 38 °C) and the state of the appli-
ance. In case of a failing radio contact, the display indicates no and a cyclical, flash-
ing radio symbol (see Troubleshooting).
If the water heater supplies a shower, the water temperature is limited to a maximum
of 55 °C. Refer to the installation instructions of the water heater.
Registration of remote control at the instant water heater
The remote control is registered as-delivered condition.
Only register again after performed work reset at the DSX or when the remote control
display continually indicates no”.
1. Make sure that the power supply to the instantaneous water heater is switched on
(fuse).
2. Remove the batteries until the display expires. After inserting the batteries, the dis-
play indicates all symbols for about 4seconds. During this time, press and hold the
arrow keys and
for a short time. Then the display shows the current channel
(1to99) and a flashing radio symbol.
3. Using the arrow keys and
chooses the desired channel. Press key to confirm
the selected channel number. The display changes to registration mode and shows
--as well as a flashing radio symbol.
4. Place the remote control directly in front of the instantaneous water heater.
5. The display switches to the setpoint value display.
Note: For initial installation we basically recommend to change the radio channel.
In the case of an unsuccessful registration the display indicates no by a flashing radio
signal after 45seconds. The remote control quits the registration process and switches
to standby mode. By pressing a key the registration process will be repeated.
Notes:
With no remote control registered or without working radio connection, the instan-
taneous water heater heats to the prior selected set temperature.
For the professional: After a reset at the water heater (refer to installing instructions,
chapter “Reinstallation”) a registration is required!

Other manuals for clage DSX

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the clage DSX and is the answer not in the manual?

clage DSX Specifications

General IconGeneral
Brandclage
ModelDSX
CategoryWater Heater
LanguageEnglish

Related product manuals