DSX SERVOTRONIC MPS
®
26
4. Remote control
Safety notes
• At malfunction of the remote control remove the batteries immediately.
• Do not expose the remote control to moisture.
• Flat batteries can leak and damage the remote control. Hence, replace flat batteries
right away as soon as battery symbol lights up in the display or the remote control
does not response after keystroke.
• When the remote control is not to be used in the long term, remove the batteries.
• After a keystroke the remote control refreshes every 10 seconds when water is flow-
ing. When the water flow stops the remote control refreshes again 3 more times.
• Without working radio connection, the appliance heats to the prior selected set
value.
Battery replacement
Replace the batteries with new AAA-batteries when the battery symbol flashes up.
Do not use rechargeable batteries!
Disposal
Batteries may contain environmentally hazardous substances. Therefore, used bat-
teries must be disposed of at special collecting points and not be mixed with general
household waste.
At the end of the remote control’s lifetime, the batteries must be disposed of separate
from the appliance.
Select preset temperature
A1 A2
B1 B2
Store temperature
2
Press
≥ 3 sec
Display of new value (e.g. 43 °C)
Set required
temperature
(e.g. 43 °C)
4 3
1
FX programme buttons
The two programme buttons allow to quickly select the preset temperature. When
pressing a programme key, the preset temperature is selected and displayed.
The factory setting for programme
is 35 °C and for programme it is 48 °C. You can assign your own settings for the
programme keys:
• Prolonged pressing of the programme
key stores the previously selected temperature. The display changes from ”P1” or
“P2“ to the newly stored temperature value. This newly set temperature is now
available to you each time you press the corresponding program key.
To Next Page
Loading...
Need help?
General
