Need help?Do you have a question about the Clarion APX4360 APX4360 APX4360 and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| RMS Power @ 4 Ohms | 60W x 4 |
| RMS Power @ 2 Ohms | 90W x 4 |
| Bridged RMS Power @ 4 Ohms | 180W x 2 |
| Frequency Response | 10Hz - 50kHz |
| THD at Rated Power | 0.05% |
| Bass Boost | +12dB @ 45Hz |
| Input Sensitivity | 200mV - 4V |
Critical steps for achieving a good chassis ground connection to minimize resistance and noise.
Step-by-step guide to set the gain control for optimal system performance and final checks.
Instructions for setting the crossover mode and frequency on applicable amplifier models.
Procedures for verifying system operation, listening for audio quality, and checking balance.
Troubleshooting steps for common causes of no audio output from the amplifier.
Diagnosing and resolving issues where the amplifier turns off due to thermal protection.
Identifying causes of distorted audio, including gain setting and speaker cone damage.
To Next Page
