Water droplets may form on Let
dry
for about 1 hour with the power on
the internal lens when the
car is parked in a humid
place
Compact disc Another compact disc is
cannot be loaded already loaded
Eject the compact disc before loading the new one
Replace with a compact disc with no scratches
Clean the compact disc with a soft cloth
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol
Replace with a fuse of the same amperage If the
fuse blows again, consult your store
of
purchase
Consult your store
of
purchase
Turn off the power, then press the OPEN button
[]]
and remove the
DCP.
Press the reset button for about 2 seconds with a thin
rod
1 Turn the unit off
2 Remove all wires attached to the power antenna
lead Check each wire for a possible short to
ground using an ohm meter
3 Turn the unit back on
4 Reconnect each amplifier remote wire to the
power antenna lead one by one If the amplifiers
turn off before all wires are attached, use an
external relay to provide remote-on voltage
(excessive current required)
Compact disc is heavily
scratched or warped
DCP or source unit
connectors are dirty
Compact disc is dirty
The microprocessor has
malfunctioned due to noise,
etc
Power antenna lead is
shorted to ground or
excessive current is required
for remote-on the amplifiers
or power antenna
Incorrect wiring
Nothing happens
when buttons are
pressed
Sound is bad
directly after
power is turned
on
No sound output
when operating
the unit with
amplifiers or
power antenna
attached
Power does not
turn on
(No sound is
produced)
DXZ615
31
To Next Page
Loading...
Need help?
General
