Remote control unit
Inserting the Batteries
Operationg range: 30°
in
all directions
Signal transmitter
1.
Turn the remote control unit over, then slide
the rear cover
in
the direction of the arrow.
2.
Insert the AA (SUM-3, R-6/1.5V) batteries
that came with the remote control unit facing
in
the directions shown
in
the figure, then
close the rear cover.
Notes:
Using batteries improperly can cause them to
explode.
Take
note
of
the following points:
• When replacing batteries, replace both batteries
with
new
ones.
• Do
not
short-circuit, disassemble
or
heat batteries.
• Do
not
dispose
of
batteries into fire
or
flames.
• Dispose
of
spent batteries properly.
10 DXZ945MP
Rear side
Rear cover
To Next Page
Loading...
