I
Attaching the
DCP
1.
Insert the DCP
so
that the ® section
on
the
right side of the DCP catches on the hook
@
on the unit.
2.
Press the left side © of the DCP carefully to
fit it
in
place.
• The DCP can easily be damaged by shocks.
After removing
it,
be careful not to drop it
or SUbject it to strong shocks.
• If the [RELEASE] button is pressed and the
DCP is not locked into place,
it
may fall out
from vibration of the car. This can break the
DCP,
so after removing it, either install it on
the unit or put it
in
its DCP case.
• The connector connecting the unit and the
DCP is
an
extremely important part. Be
careful not to damage
it
by pressing on it
with fingernails, screWdrivers, etc.
Note:
• If the DCP is dirty, wipe
off
the dirt with a soft,
dry
cloth
only.
3.
Pull the DCP toward you and remove
it.
Removing the DCP
1.
With the SLOPING CONSOLE closed, turn
off the power.
2.
Press the [RELEASE] button deeply to open
the
DCP.
c-r[RELEASE]
button
~>.--"':.r---~-:::::,j~",
The control panel can be detached to prevent
theft. When detaching the control panel, store it
in
the DCP (DETACHABLE CONTROL PANEL)
case to prevent scratches.
We
recommend taking the DCP with you when
leaving the car.
• Always close the SLOPING CONSOLE
before removing the
DCP.
• If you remove the DCP with the SLOPING
CONSOLE open, the sloping console
closes immediately. Be careful not to get
your fingers caught.
DXZ945MP
9
To Next Page
Loading...
