I
If
an
error occurs, one of the following displays is displayed.
Take the measures described below to eliminate the problem.
A DISC is caught inside the CD deck and
is
not ejected.
A DISC cannot
be
played due
to
scratches,
etc.
A DISC
is
loaded upside-down inside the
CD deck and does not
play.
AMP GUARD The speaker protection circuit
is
operating.
During this operation, if any volume
operation
is
performed, the display shows
"AMP GUARD"-
"AMP GUARD" sometimes functions when
special test signals are used.
A DISC inside the CD changer is not
loaded.
A DISC inside the CD changer cannot be
played due
to
scratches, etc.
A DISC inside the CD changer cannot be
played because it
is
loaded upside-down.
A DISC inside the DVD changer cannot be
played.
A DISC cannot be played due to scratches,
etc.
A DISC inside the DVD changer cannot be
played because it
is
loaded upside-down.
Parental level error
Region code error
This
is
a failure of CD deck's mechanism and
consult your store of purchase.
Replace with a non-scratched,
non-warped-disc.
Eject the disc then reload
it
properly.
1.
Turn down sound volume. Function can
also
be
restored by turning the power off
and
on
again.
(Speaker volume is reduced automatically
when the speaker protection circuit oper-
ates).
2.
If the sound is muted again, consult our
service department.
This
is
a failure of CD changer's mechanism
and consult your store of purchase.
Replace with a non-scratched, non-warped
disc.
Eject the disc then reload it properly.
This is a failure of DVD mechanism and con-
sult your store of purchase.
Retry or replace with a non-scratched, non-
warped-disc.
Eject the disc then reload it properly
Set the correct Parental level.
Eject the disc and replace correct region
code disc.
If
an
error display other than the ones described above appears, press the reset button. If the problem
persists, turn off the power and consult your store of purchase.
58
DXZ945MP
To Next Page
Loading...
