COD."TIC
CODEMATIC function
When "CODEMATIC"
is
set to "ON", and the
power is turned
ON
with the DCP attached, the
Touch Code display appears. Touch the display
in
the order that was set
in
the adjust mode.
Be
sure
to
lower
the
volume
before
switching
the
unit
off
or
the
ignition
key. The
unit
remembers
its
last
volume
setting. If
you
switch
the
power
OFF
with
the
volume
up,
when
you
switch
the
power
back
ON,
the
sudden
loud
volume
may
hurt
your
hearing
and damage
the
unit.
IBasic Operations
Turning ON/OFF the power
Turning on
Note:
• Be careful when using this unit for a long time
without running the engine.
If
you drain the car's
battery too
far,
you
may
not be able
to
start the
engine
and
this can reduce the service life
of
the
battery
1.
Press the [ROTARY] knob.
The mode that was previously active
is
displayed.
System check
The first time that this unit
is
turned
on
after wire
connections are completed, this unit checks
which equipment is connected. (This is called
the "system check.") When the power
is
turned
ON, and "System Check" is displayed, follow
the procedure below to perform the system
check.
1.
When "System Check" appears
on
the
display, press the [ROTARY] knob.
The system check starts.
When the system check is complete,
"Completed" appears
on
the display.
2.
Press the [ROTARY] knob again.
The main display for the radio mode
appears.
For details
on
the CODEMATIC function, see
"Using
the
security
function"
(cf. page 44).
Turning off
1,
Hold down the [ROTARY] knob for 1 second
or longer.
*
If
the power is turned OFF with the clock
displayed, the clock will stay displayed
even after the power
is
turned
OFF.
Selecting a mode
1.
Press the [ROTARY] knob to change the
operation mode.
2.
Each time you press the [ROTARY] knob,
the operation mode changes
in
the following
order:
Radio
mode
-+
SIRIUS
mode
-+
CD/MP3
mode
-+
CD
changer
mode
-+
DVD
changer
mode
-+
TV
mode
-+
AUX mode
-+
Radio
mode
...
* External equipment not connected with
CeNET is not displayed.
Adjusting the volume
1.
Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
* The volume level
is
from a(minimum) to
33 (maximum).
12
DXZ945MP
To Next Page
Loading...
