Switching the operation mode
There are 2 basic operation modes: standard
operation and simple operation.
1.
In
the main display screen, touch and hold
the left of the display for 1 second or longer.
The operation mode is switched.
In
the simple operation, the operations of
touching
-t
I)
J"
or
+1)+
in
the radio mode or
CD mode main display screen are not required,
and this unit can be used by performing simple
operation.
Note, however, that the following operations are
not available
in
the simple operation.
• Preset tuning, folder selection, disc selection,
and other operations that involve touching
-t
I)
J"
on the right of the display
• Display switching operations (cf. page 13)
• Title display switching operations (cf. page 14)
• Operations for displaying title entry screens.
In
screens (e.g. list display, adjust mode, etc.)
other than the main display, there is no
difference between the standard operation
and the simple operation.
Descriptions given
in
this manual are mainly for
the standard operation. For descriptions for
operations
in
the simple operation, refer to the
descriptions for the screen displays
in
the radio
mode or the CD mode.
Basic Operations
Switching the display
1.
Touch the center of the display.
Each time you touch the display, it changes
as follows:
Title display
Spectrum Analyzer display
Screen saver
When the screen saver function is set to "ON",
and you do not operate this unit for about 30
seconds, the screen saver will be displayed. For
details, see page 36.
DXZ945MP
13
To Next Page
Loading...
