Disc is dirty. Clean the disc with a soft cloth.
1.
Turn the unit off.
2.
Remove all wires attached to the power antenna
lead. Check each wire for a possible short to
ground using an ohm meter.
3.
Turn the unit back on.
4.
Reconnect each amplifier remote wire to the
power antenna lead one by one. If the amplifiers
turn off before all wires are attached, use
an
external relay to provide remote-on voltage
(excessive current required).
Consult your store of purchase.
Replace with a fuse of the same amperage. If the
fuse blows again, consult your store of purchase.
Turn off the power, then
press the
[RELEASE]
~~
Reset
button
button and remove the
DCP.
~~.
Press the reset button with
~~
a thin rod.
~
.
Use MP3IWMA files encoded properly.
Wipe the dirt off with a soft cloth moistened with
cleaning alcohol.
With the slooping console open, press and hold the
[~]
button for 3 seconds or longer.
The foreign matter is forcibly ejected.
MP3IWMA files are absent
in
Write MP3IWMA files onto the disc properly.
a disc.
File system is not correct. Use
IS09660
level
1,
2 or JOLIET
or
Romeo file
system.
Power antenna lead is
shorted to ground or
excessive current is required
for remote-on the amplifiers
or
power antenna.
DCP or main unit connectors
are dirty.
The microprocessor has
malfunctioned due to noise,
etc.
Incorrect wiring.
Files are not recognized as Use MP3IWMA files encoded properly.
an
MP3IWMA file.
There is a disc other than a
compact disc or foreign
matter already
in
place.
Disc is heavily scratched or Replace with a disc with no scratches.
warped.
MP3IWMA files are not
encoded properly.
No sound output
when operating
the unit with
amplifiers or
power antenna
attached.
Sound
is
cut or
skipped.
Noise
is
generated or
noise is mixed
with sound.
56
DXZ945MP
To Next Page
Loading...
