6. OPERATIONS
Note:
.•
Be sure to read this chapter referring to the front diagrams
of
chapter "CONTROLS" on page ii (unfold).
Basic Operations
Be
sure
to
lower the volume before
switching
off
the unit power
or
the ignition
key. The unit remembers its last volume
setting. If you switch the power off with the
volume up, when you switch the power back
on, the sudden loud volume may hurt your
hearing and damage the unit.
Turning
on/off
the
power
Note:
• Be careful
about
using this unit for a long time
without running the engine.
Ifyou drain the car's
battery too far, you
may
not be able to start the
engine
and
this cal! reduce the service life
of
the
battery.
1.
Press the [SRC] button.
2.
Press and hold the [SRC] button for 1
second or longer to turn off the power for the
unit.
Note:
• System check .
The first time this unit is turned on afterthe wife
connections are completed, it must
be
checked
what equipment is connected. When the
power
is
turned on, the US-CHECK"appears in the display,
then the unit returns to the clock display mode.
The system check starts within the unit. When the
system
checkis
complete, press the
[SRCj
button
again.
10 DXZ275MP
/DXZ375MP
Selecting a mode
1.
Press the [SRC] button to change the
operation mode.
2.
Each time you press the [SRC] button, the
operation mode changes
in
the following
order:
Radio
..
(Satellite radio)
..
CD/MP3IWMA
..
(iPod BB)
..
(CD changer)
..
(DVD
changer)
..
(TV)
..
AUX
..
Radio...
*External equipment not connected with
CeNET is not displayed.
Adjusting
the volume
1.
Turning the [ROTARY] knob clockwise
increases the volume; turning it
counterclockwise decreases the volume.
*The volume level is from 0 (minimum) to 33
(maximum).
Switching the display
Press the
[0]
button to select the desired
display.
*If the button operation is performed with the
screen saver function on, the operation display
corresponding to the button operation is shown
for about 30 seconds and the display returns to
the screen saver display.
For details, refer to the subsection
"Turning the
screen saver function on
or
off"
in
section
"Operations Common
to
Each Mode".
To Next Page
Loading...
Need help?
General
