36
• Tap
to run the simulation at normal speed and with voice guidance
instructions announced. This option is for demonstration purposes, or for checking
difficult parts of the route in advance.
3. The simulation can be aborted any time by tapping the
button or by tapping the map,
and tapping it again.
3.4 Enabling Safety Mode
This feature is available in Advanced mode only.
Safety Mode disables the touch screen above 10 km/h (6 mph) to keep your attention on the road.
While driving, you will not be able to set a new destination or to change settings. The only screen
control that remains enabled is the gesture that puts you back on the Map screen.
The procedure is explained starting from the Map screen.
Tap the following buttons:
, , , .
3.5 Pausing the active route
You do not need to pause the active route: when you start driving again, Clarion EZ Drive restarts the
voice instructions from your position.
3.6 Deleting the active route
The easiest way to delete the active route in both Simple mode and Advanced mode is to open the
Route Information screen by tapping the Turn Preview field (
) on the Map screen, and then
tapping
.
In Advanced mode, you have another option. Tap the following buttons:
, ,
.
Note!
If via points exist in the active route, you cannot delete the route immediately on the
Route Information screen. Tap
repeatedly until all via points
disappear and the
button appears. Tap it to cancel the whole route.
To Next Page
Loading...
Need help?
General
