Why won't my Clarion Hino PJ-4605T Car Receiver turn on?
The Clarion Car Receiver might not turn on because the fuse is blown. Replace it with a fuse of the same amperage. If it blows again, consult your dealer. Also, check for incorrect wiring; if found, consult your dealer.
What to do if there is no sound heard from Clarion Hino PJ-4605T?
If you're not hearing any sound, the speaker protection circuit may be operating. Try turning down the sound volume, or turn the power off and on again. If the sound is muted again, consult our service department.
Why is there no sound output when operating Clarion Car Receiver with amplifiers or power antenna?
This could be because the power antenna lead is shorted to ground, or excessive current is required for remote-on the amplifiers or power antenna. To resolve this: 1. Turn the unit off. 2. Remove all wires attached to the power antenna lead and check each wire for a possible short to ground using an ohm meter. 3. Turn the unit back on. 4. Reconnect each amplifier remote wire to the power antenna lead one by one. If the amplifiers turn off before all wires are attached, use an external relay to provide remote-on voltage (excessive current required).
General| Brand | Clarion |
|---|---|
| Model | Hino PJ-4605T |
| Category | Car Receiver |
| Channels | 4 |
| CD Playback | Yes |
| MP3 Playback | Yes |
| WMA Playback | Yes |
| USB Port | Yes |
| Auxiliary Input | Yes |
| Bluetooth | No |
| Display | LCD |
To Next Page
