Clarion HX-D2 - 5 Remote Control; Inserting the Batteries

HX-D2 9
English
5. REMOTE CONTROL
[
FNC
]
[
BND
]
[
MUTE
]
[
PS/AS
]
[ ],[ ]
[
DISP
]
[
ADJ
]
[
A-M
]
[
RDM
]
[
DISC
]
[
RPT
]
[
SCN
]
[ ],[ ]
[ ],[ ]
[ ]
[ ], [ ]
Remote control unit
Inserting the Batteries
1. Turn the remote control over, and remove the
rear cover with a sharp-pointed object while
pressing in the direction of the arrow.
2.Insert batteries (CR2025) making sure that they
face the directions shown in the figure.
3. Press in the cover until you hear it click into place.
Notes:
Using batteries improperly can cause them to
explode. Take note of the following points:
• When replacing batteries, replace both batteries
with new ones.
• Do not short-circuit, disassemble or heat batteries.
• Do not dispose of batteries into fire or flames.
• Dispose of spent batteries properly.
Receiver for remote control unit
Operating range: 30˚ in all directions
Signal transmitter
Rear side
CR2025 Battery
Rear cover