100 NX702 English
You can use digital maps interactively: you can zoom in and out (increase or decrease the scale), you
can tilt them up and down, and rotate them left and right. In GPS-supported navigation, digital maps
facilitate route planning.
North-up map orientation
In North-up mode the map is rotated so its top always faces North. This is the orientation for example in
Find on Map.
Road Safety Camera
Special alert points for speed, red light or bus lane cameras. Different data sources are available. You
can configure Clarion Mobile Map to warn you when you approach one of these cameras.
Detecting the location of Road Safety Cameras is prohibited in certain countries. It is the sole
responsibility of the driver to check whether this feature can be used during the trip.
The software is capable of showing and warning for more than just cameras. Various other types of
proximity alert points like school zones and railroad crossings are also available.
Route
A sequence of route events, i.e. maneuvers (for example, turns and traffic circles) to reach the destination.
The route contains one start point and one or more destinations. The start point is the current (or last
known) position by default. If you need to see a future route, the start point can be replaced with any
other given point.
Track-up map orientation
In Track-up mode the map is rotated so its top always points in the current driving direction. This is the
default orientation in 3D map view mode.
Vehimarker
The current position is shown with a red arrow on the map by default. The direction of the red arrow
shows the current heading. This position marker can be replaced with different 3D vehicle symbols. You
can even specify different Vehimarkers for different route types (depending on which vehicle type is
selected for route calculation).
To Next Page
Loading...
Need help?
General
