Clarion Series

English
10
NX302E
Anti Theft
• AntiTheftcode
You can set an Anti-theft code. After set
successfully, when Battery wire reconnect,
you need to input the Anti-theft code.
1. Long press the [General] button until a
dialog box popped up. Touch [Yes] to set
a personal code of Anti-Theft.
2. Input a 4-digit code. Touch [OK] to conrm.
Then input it again for conrmation.
3. To remove the code, long press the
[General] button and i nput the old
password.
Note:
Please make a note of the Anti theft code not
to forget. if the right code is not inputted, it
becomes impossible to operate this unit.