13
take-over mode
The Override take-over feature allows the vehicle to remain running
after the key has been removed from the ignition. This feature is use-
ful for occasions when you wish to exit and lock the vehicle for short
periods of time, but would like to leave the motor running and the cli-
mate controls on.
To perform Take-over mode:
1. Before turning off the engine, press and release on the
remote twice in 3 seconds (or press and release the optional
momentary switch). The parking lights will flash for confirmation.
2. Turn the ignition key to the OFF position. (The engine will stay running.)
3. The engine will run until the pre-programmed time elapses or a
shut-down input is received. (See the previous remote engine start
section for a complete list of shut-down inputs.)
NNOOTTEE::
This feature will not work if the brake pedal is being pressed.
short-run/turbo
Short-run turbo mode keeps the engine running after arriving at you
destination for a programmable period of 1, 3 ,5 or 10 minutes. This
allows the system’s timer to conveniently cool down the turbo after you
have left the vehicle.
To activate:
1. Park the vehicle and set parking brake.
2. Remove your foot from the brake pedal and leave the engine running.
To Next Page
Loading...
Need help?
General
