34 WXZ468RMP
280-8262-00
English
1. Perform the following operation depending
on the connected model.
Press and hold the [ADJ] button for 1 sec-
ond or longer to switch to the RDS mode.
2. Turn the [SEARCH] knob to select “INFO
SEL”, then press the [SEARCH] knob to en-
ter “INFO SEL” mode.
3. Turn the [SEARCH] knob to select an infor-
mation item. You can select any of 6 items:
Travel ➜ Warning ➜ News ➜ Weather ➜
Event ➜ Special ➜ Travel ➜ ...
4. Turn the [A-MODE] knob to set the informa-
tion item for ON or OFF.
5. Press the [SEARCH] knob to store the set-
ting.
6. Press the [ADJ] button to return to the pre-
vious display.
PTY
This function enables you to listen to the se-
lected programme type, irrespective of the func-
tion mode.
∗ One common PTY can be selected for DAB or RDS.
∗ Of DAB PTY and RDS PTY, the PTY which is re-
ceived earlier takes priority over the other.
∗ PTY broadcasts are not yet available in all coun-
tries.
∗ In the INFO standby mode, INFO stations have pri-
ority over PTY stations.
∗ In the TA standby mode, TP stations have priority
over PTY stations.
∗ For details on “PTY”, refer to the section “RDS op-
eration” of each owner’s manual.
●Setting the PTY standby mode
●Cancelling the PTY standby mode
●Cancelling a PTY interrupt broadcast
●Selecting PTY
●PTY seek
●PTY preset memory
Emergency broadcast
When an emergency broadcast is received, all
the function mode operations are stopped.
“ALARM” appears in the display and the emer-
gency broadcast can be heard.
∗ For details on “Emergency broadcast”, refer to the
section “RDS operation” of each owner’s manual.
●Cancelling an emergency broadcast
Digital Radio / DAB Operations
Switching the PTY and INFO display
language
You can select one of 4 languages (English,
German, Swedish or French) for the PTY and
INFO shown in the display.
∗ The factory default setting is “ENGLISH”.
∗ For details on “Switching the PTY display lan-
guage”, refer to the section “RDS operation” of
each owner’s manual.
Volume setting of TA, INFO,
emergency broadcast (ALARM) and
PTY
The volume for TA, INFO, ALARM and PTY in-
terrupts can be set during TA, INFO, ALARM
and PTY interrupt. Perform the following opera-
tion depending on the connected model.
∗ The factory default setting is “15”.
During a TA, INFO, ALARM or PTY interrupt,
turning the [VOLUME] knob to set the volume to
a desired level (0 to 33).
∗ When the TA, INFO, ALARM or PTY interrupt ends,
the volume returns to the level it had before the
interrupt.
To Next Page
Loading...
