Section 4. Operating Procedures
4.54.5
Load Handling
• Lower forks completely before entering load.
• Center forks with load as you approach.
• Enter load as far as possible.
• Make sure the lifting area is clear before lifting load.
• Raise forks completely before moving truck.
• Avoid operating hazards and observe general safety rules while
moving load.
• Always approach load deposit areas squarely and cautiously.
• Be especially careful when placing loads near water pipes, electrical
wiring or outlets, steam pipes, heaters, and other dangerous or fragile
equipment.
• After placing load in position, lower the forks completely.
• Withdraw the forks squarely from the load.
Load Handling
To Next Page
Loading...
