14
UNPACKING & PARTS IDENTIFICATION
Unpack and lay out the components, checking against the following list. Any
damage or deficiency should be reported to your CLARKE dealer immediately.
Most of the components are stored within the side compartment. To open the
compartment, pull the side panel up sharply.
The cover may be quite tight when new, so exercise a little care.
MIG 90EN,105EN & 110EN
1. Rubber Feet with washers and
screws (4 pcs)
2. 2-Piece Welding Mask
3. Welding Mask handle, complete
with plastic nut and 2xplastic screws.
4. Package containing 1x Clear
Glass and 1x Dark Glass Lens
5. Flux cored Wire Spool
6. Spare welding tip (1 pc)
MIG151EN
1. Foot with screw and washer
2. Wheels with retaining clips (2 pcs)
3. Axle
4. Spare welding tips (2 pcs)
5. 2-Piece Welding Mask
6. Welding Mask handle, complete
with plastic nut and 2xplastic screws.
7. 1xPackage containing 1x Clear
Glass and 1x Dark Glass Lens
8. Flux cored Wire Spool
To Next Page
Loading...
