14
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
MAINTENANCE
CLEANING
1. Always turn off the unit and disconnect from the power supply before
cleaning.
2. Clean the outside surfaces of the unit with a duster or a soft, moist cloth. Do
not use solvents which could damage the plastic components.
3. If the air filter is blocked with dust,
the efficiency of the unit will be
reduced. To remove the air filters,
pull them out as shown.
4. Wash the air filters gently in warm
water with a mild detergent. Rinse
the filters and dry them gently out
of direct sunlight.
5. Push the filters back into position.
STORAGE
1. At the end of the season, remove the plug to drain out any water. Tilt the
unit back to ensure all the water is removed.
2. Set the unit on FAN mode, then press the fan button until the lower fan
works. Operate the unit in FAN mode until all the drain outlet is dry. This will
discourage the growth of mildew inside the unit.
3. Switch off the unit and disconnect the power cable.
4. Remove and contract the exhaust duct and store it carefully.
5. Cover the unit with a plastic bag and store it in a dry location.
6. Remove the batteries from the remote control.
DE-COMMISSIONING THE PRODUCT
Should the product become completely unserviceable and require disposal, it
should be taken to a recycling centre for disposal according to the European
WEEE Directive or according to local regulations.
To Next Page
Loading...
Need help?
General
