11
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
ASSEMBLY
1. Rest the bandsaw assembly on its
side, supported by a block of
timber as shown.
• Protect the upper casing from
damage with cardboard or rag
where it lays on the ground.
2. Attach the legs using the M8 x 12
socket head bolts and 8 mm flat
washers.
3. Fit the short and long braces to
the legs using M6 x 12 coachbolts,
6 mm flat washers and M6 nuts,
inserting the bolts from outside.
• Do not fully tighten the nuts at this
stage.
4. Stand the bandsaw upright on level ground and tighten all the bolts and
nuts, ensuring the assembly is level.
5. Fit the table to the bandsaw using
M8 x 10 bolts and 8 mm flat
washers. Ensure the saw blade is
central in the table slot.
To Next Page
Loading...
