12
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
6. Secure the guide rail to the table
with the four locking knobs.
7. Fit the tool set holder to the
machine frame using the M4x10
screws. Install the loose tools (4 x
hex keys and a spanner).
8. Fit the push stick hook to the side
of the machine and tighten using
the unique locking nut.
9. Hang the push stick on the hook.
10. Fit the rip fence to the table over
the guide rail.
11. Store the mitre gauge in the loops provided on the lower frame base.
.
To Next Page
Loading...
