22
TROUBLESHOOTING
PROBLEM CAUSE SOLUTION
The generator fails
to start
Engine s
witch is off Set the engine switch to ‘on’
Not enough oil in the
generator
Add more
oil, See page 9
No fuel Add more fuel, See page 10
Spark plugs not working
correctly
Change the spark plugs, See
page 20
The generator fails
to
genera
te
electricity
The device you are trying to
power is faulty
Make sure the device you want to
power is working properly
The overload indicator is on Remove
the appliance
immediately, do not connect any
appliance that requires more than
1 KVA.
(dc supply only) The DC
Ov
erload protector has
activated.
Press the reset button. See
page 15
The generator is
d
ifficult to start
The air filter is
dirty Clean the air filter. See page 19
If this does not solve your problem, please contact the Clarke service
department. see below.
PARTS AND SERVICING
For Parts & Servicing, please contact your nearest dealer, or
CLARKE International, on one of the following numbers.
PARTS & SERVICE TEL: 020 8988 7400
PARTS & SERVICE FAX: 020 8558 3622
or e-mail as follows:
PARTS: Parts@clarkeinternational.com
SERVICE: Service@clarkeinternational.com
To Next Page
Loading...
Need help?
General
