11
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
6. Check when installing that the
spark plug has the correct
clearance by measuring with a
feeler gauge and adjusting the
side electrode as required.
• Clearance should be 0.7-
0.8mm.
• The recommended spark plug
is LDF7RTC.
CHANGING THE OIL
The oil in the engine should be changed after the first 20 hours use and
thereafter every 6 months or 100 running hours.
Remove the dipstick and drain plug and then drain the oil. Re-fill and check
the level as described on page 6.
We recommend SAE15W-40 or equivalent motor oil.
ENVIRONMENTAL PROTECTION
One of the most damaging sources of pollution is oil. Do not throw away used
oil with domestic refuse or flush down a sink or drain. Collect old oil in a leak-
proof container and take it to your local waste disposal site.
STORAGE
After use, drain the pump body whenever there is danger of freezing, and if
the pump has been used with contaminated or salty water, It should be
thoroughly flushed with clean water following use, both inside and out and
drained before replacing the drain plug.
Always transport the pump with the fuel cock turned off and keep the unit
level to prevent any fuel from spilling.
If the pump is not to be used for some time, it should be flushed thoroughly
with clean water, and drained completely before storing in a clean dry
environment. Additionally, it should be prepared as follows:
CAUTION: PROLONGED EXPOSURE TO USED OIL IS HARMFULL,
ALWAYS WASH YOUR HANDS THOROUGHLY AFTER HANDLING USED
OIL.
To Next Page
Loading...
Need help?
General
