5
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
BEFORE USE
FITTING THE FEET
1. Fit the 4 x rubber feet to the frame
using the nuts and washers
supplied.
FILLING WITH OIL
This pump is not supplied containing
engine oil or fuel. Use an engine oil of
SAE 15-40 rating unless operating at
very high or low ambient
temperatures.
To fill the engine crankcase with oil:
1. Remove the filler plug/dipstick.
2. Fill the unit with oil until visible
inside.
3. Check the level by inserting the
dipstick back into the filler tube
and checking the level is within
the indicated range. If correct
replace the dipstick/filler cap
To Next Page
Loading...
Need help?
General
