6
Parts & Service: 020 8988 7400 / E-mail: Parts@clarkeinternational.com or Service@clarkeinternational.com
.FILLING WITH FUEL
• Use unleaded petrol.
1. Open the fuel cap and top up as
required. Located within the fuel
tank is a filter. Check this filter
periodically and remove any
contaminants which may have
accumulated. Do not fill above
the fuel filter shoulder.
2. After refuelling, tighten the fuel
filler cap securely.
INSTALLING THE PUMP
1. Position the pump on a firm foundation and as near to the water source as
possible.
2. Connect the suction and
discharge hoses to the pump
using the hose clamps and sealing
rings supplied, to achieve an
airtight seal.
• There must be no damage to
the hoses which must be
adequately protected and
supported.
NOTE: Hoses or pipes should be
supported independently
and not carried by the
pump.
WARNING: WIPE UP ANY SPILT FUEL BEFORE RUNNING THE PUMP.
ALLOW THE ENGINE TO COOL DOWN BEFORE REFUELLING
To Next Page
Loading...
