Clarke Vantage 14 Original Instruction

ENGLISH
14
Instructions For Use - VANTAGE 14
AFTER USING THE MACHINE
After working, before leaving the machine:
Empty the tanks (23 and 22) as shown in the previous 1.
paragraph.
Perform the daily maintenance procedures (in the following 2.
paragraph).
Store the machine in a clean and dry place, with the brush/3.
pad-holder and the squeegee blades lifted or removed.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days,
proceed as follows:
Perform the procedures shown in the previous paragraph.1.
Open the cover (4) and disconnect the battery connector 2.
(7).
Store the machine in a clean and dry place.3.
To safeguard the brush or squeegee blades, turn the 4.
handlebar (1) forward and park the machine as shown in
gure 3.
Figure 3
P100451
FIRST PERIOD OF USE
After the rst 8 hours, check the machine fastening and connecting parts for proper tightening. Check the visible parts for integrity
and leakage.
MAINTENANCE
The lifespan of the machine and its maximum operating safety are ensured by correct and regular maintenance. The following chart
provides the scheduled maintenance. The intervals shown may vary according to particular working conditions, which are to be
dened by the person in charge of the maintenance.
WARNING!
Maintenance procedures must be performed with the machine switched off and the battery/battery charger cable
disconnected.
Moreover, carefully read the instructions in the Safety chapter.
All scheduled or extraordinary maintenance procedures must be performed by qualied personnel, or by an authorized Service
Center. This Manual describes only the easier and most common maintenance procedures.
NOTE
For other maintenance procedures shown in the Scheduled Maintenance Table, refer to the Service Manual that can be
consulted at any Service Center.
SCHEDULED MAINTENANCE TABLE
Procedure
Daily, after using
the machine
Weekly
Every six
months
Yearly
Squeegee cleaning
Brush cleaning
Tank and vacuum grid cleaning
Squeegee blade check and/or replacement
Battery charging
Screw and nut tightening check (1)
Brush deck rubber pad check and/or replacement (2)
Brush deck end-of-stroke cable check and/or replacement (2)
Brush deck rubber ange check and/or replacement (2)
And after the rst 8 working hours.(1)
For the relevant procedure, refer to the Service Manual.(2)
A1 ENGLISH.indd 14 03/08/2011 14.54.49

Clarke Vantage 14 Specifications

General

Brand	Clarke
Model	Vantage 14
Category	Floor Machine
Language	English