Clarke CLEAN TRACK 16 User Manual

Electronic Service
Manuals
This electronic document is provided as a service to our customers.
We do not create the contents of the information contained in this docu-
ment. Should you have detailed questions pertaining to the information
contained in this document, you may contact Michco, or the manufac-
turer which provided the original information in this electronic deliver-
able. Michco’s only part in this electronic deliverable was the electronic
assembly process. By providing this manual on line we are not guaran-
teeing parts availability.
You may contact Michco through the following methods:
Phone (517) 484-9312 or (800) 331-3339
2011 N. High St. -- Lansing, Michigan -- 48906
Fax: (517) 484-9836
Email: CustServe@Michco.com
Web site: www.Michco.Com
Parts Web site: www.FloorMachineParts.Com
Order Parts on Line at:
www.FloorMachineParts.Com
Directly to Parts & Service:
By Email: Shop@Michco.com
By Fax: (517) 702-2041
By Voice: Use numbers above.
Serving the Cleaning Industry Since 1922
Notice: All copyrighted material remains property of original owners, all trademarks are property of respective owners.
Manuals are subject to Manufacturer’s reproduction limitations. Originals or reproductions were provided by manufacturers
through a request. We make no warranty as to the correctness of information provided in this document and you assume
all risk. By placing these manuals on line we are not declaring our corporation to be an manufacturer authorized dealer or
provider, please check our web site for authorized manufacturers we represent.

Clarke CLEAN TRACK 16 Specifications

General

Brush Motor	0.75 hp
Pad/Brush Speed	175 RPM
Cleaning Path	16 inches
Weight	85 lbs
Machine Type	Floor Machine
Machine Weight	85 lbs
Power Cable	50 feet

Summary

Important Safety Instructions

General Safety Precautions

Essential safety rules for operating the machine to prevent hazards and ensure proper use.

Authorized Personnel Maintenance

Solution Pump Removal

Procedure for safely removing the solution pump from the machine for service.

Solenoid Valve Removal (Standard Models)

Instructions for removing the solenoid valve on standard machine models.

Solenoid Valve Removal (Wash & Rinse Model)

Instructions for removing the solenoid valve on Wash & Rinse models.

DEMA Injector Maintenance (Wash & Rinse Model)

Brush Motor Removal

Steps for safely removing the brush motor from the machine.

Brush Drive Belt Replacement

Vacuum Motor Maintenance

Steps for inspecting and maintaining the vacuum motor, including carbon brushes.

Troubleshooting and Specifications

Troubleshooting Circuit Breaker Issues

Common causes and solutions for circuit breaker trips to restore machine operation.

Troubleshooting Poor Water Pickup

Troubleshooting Solution Flow Problems

Troubleshooting Chemical Injection Issues