To Next PageTo Next Page
Need help?Do you have a question about the Clarke Clean Track 18 and is the answer not in the manual?
General| Brand | Clarke |
|---|---|
| Model | Clean Track 18 |
| Category | Floor Machine |
| Language | English |
Information on obtaining replacement parts and authorized repair services.
Details on locating model and serial numbers for identification.
Procedure for safely unpacking the machine upon delivery.
Identifies the primary control interface for operating the machine.
Covers the tank where used water is collected.
Holds the collected dirty water.
Prevents vacuum motor damage by shutting off when tank is full.
Covers the tank holding cleaning solution.
Filters solution before it's dispensed.
The part that contacts the floor to extract liquid.
Mechanism to detach the vacuum shoe.
Holds the cleaning solution.
Cable for connecting the machine to electrical power.
Alternative power cord configuration.
Hose for emptying solution tank and indicating level.
Container for detergent on specific models.
Controls the dispensing of cleaning solution.
Controls machine operation and accessory mode.
Adjusts solution flow rate on specific models.
Protects the brush motor from overloads.
Hose for emptying the recovery tank.
Point where the recovery hose connects.
Adjusts the downward pressure of the brush.
Connection for optional cleaning accessories.
Main power control for 230V models.
Procedure for adding cleaning solution to the tank.
General instructions before operating the machine.
Method for pre-treating carpet before extraction.
Strategy for efficient and effective cleaning of an area.
Step-by-step guide to using the machine.
Instructions for connecting and using optional accessories.
Information on using the machine on hard floors.
Steps to take after completing cleaning operations.
Routine maintenance tasks and frequency.
How to clean and maintain the vacuum shoe.
Procedure for cleaning spray nozzles.
Procedure for cleaning the solution screen.
Inspection and maintenance of the power cord.
Method for adjusting brush pressure.
Routine checks for the power brush.
Step-by-step guide to removing the brush.
Procedure for removing the solution pump.
Steps to remove the solenoid valve on standard models.
Steps to remove the solenoid valve on Wash & Rinse models.
Maintenance procedures for the DEMA injector.
Procedure for removing the brush motor.
Steps to replace the brush drive belt.
Maintenance of the vacuum motor and its carbon brushes.
Causes and solutions for circuit breaker trips.
Potential causes and remedies for inadequate water pickup.
Troubleshooting steps for lack of solution flow.
Diagnosing issues with chemical injection.
