What to do if my Clarke Floor Machine has inadequate solution flow?
If your Clarke Floor Machine isn't dispensing enough cleaning solution, there are a few things to check: * First, make sure the solution tank has enough fluid. * Next, verify that the solution tank filter ball valve is in the 'on' position. * Finally, inspect the solution filter, valves, and hoses for any clogs.
General| Brand | Clarke |
|---|---|
| Model | Clean Track® L24 56317170 |
| Category | Floor Machine |
| Language | English |
Provides essential safety guidelines for operating and maintaining the machine.
Provides a schedule for daily, weekly, monthly, and yearly maintenance tasks.
Identifies and labels the key physical parts of the machine.
Covers solution system operation, maintenance, and common issues.
Steps for removing the solenoid valve and solution pump.
Covers scrub system operation, deck, motor, and actuator removal.
Covers recovery system operation and float switch/screen maintenance.
Identifies causes of vacuum system performance issues.
Covers wheel drive system operation and common troubleshooting.
Steps to test the functionality and resistance of the R1 potentiometer.
Information on battery installation, charging, and indicators.
General guidance on connecting the actuator motor for adjustment.
Using diagnostic methods and understanding fault codes for controller issues.
Instructions to enter and utilize the machine's service test mode.
How to adjust the battery low voltage shutdown threshold.
Visual representation of the machine's electrical connections.
To Next Page