To Next Page

To Previous Page

Form No. 56043161 - Clean Track

L24 - 79

5. Release both switches. The display will now show a wrench icon or a wrench icon with a cross through it.

6. Press and release the Scrub ON Switch (J)toselectbetweenthewrenchiconforfaultdetectionenabled,orthe

wrench icon with a cross through it for fault detection disabled.

7. Oncethedesiredsettingisshown,presstheScrubOFFSwitchtosaveit.Thedisplaywillnowshowakeyiconto

indicate the procedure is done.

8. Turn the Key Switch to the off position. The new setting will be saved and will remain in effect until it is changed

again.

Note:Whenoperatingwiththefaultdetectiondisabled,thedisplaywillshowawrenchiconwithacross

throughitasareminderthatnofaultswillbelogged.

Displaying the Control Unit Revision Level

Toviewtherevisionlevelofthecontrolunit,performthefollowingsteps:

1. Turn the Key Switch (A) to the off position.

2. Press and hold the Scrub OFF Switch (H) and the Detergent System switch (B).

3. Whileholdingbothswitches,turntheKeySwitchtotheonposition.

4. Continue to hold both switches until the detergent and scrub system off indicators are green.

5. Release both switches. The display will now indicate the revision level of the control unit. The displayed value will

be a letter from A to Z.

6. Toexitthismode,turntheKeySwitchtotheoffposition.

Enabling/Disabling the Chemical Mixing System

The Clean Track

L24 comes standard with an on-board chemical mixing system. This chemical system should be

enabledatthefactoryifthemachinecomeswithit.However,thissettingcanbechangedbyperformingthefollowing

steps:

1. Turn the Key Switch (A) to the off position.

2. Press and hold the Scrub OFF Switch (H) and the Scrub ON Switch (J).

3. Whileholdingbothswitches,turntheKeySwitchtotheonposition.

4. Continue to hold both switches until the left indicator in the Scrub ON Switch (J) is on.

5. Release both switches. The display will now show the Chemical Mixing System Indicator (D1) or the Chemical

Mixing System Indicator with a cross through it. The Chemical Mixing System Indicator represents the chemical

system enabled. The Chemical Mixing System Indicator with a cross through it represents the system disabled.

6. Press and release the Detergent System Switch (B) to toggle between enabled and disabled.

7. Whenthecorrectsettingisselected,presstheScrubOFFSwitchtosaveit.Thedisplaywillnowshowakeyicon

to indicate the procedure is done.

8. Turn the Key Switch to the off position. The new setting will be saved and will remain in effect until it is changed

again.

Clarke Clean Track® L24 56317170 User Manual

Questions and Answers: