6 - Form No. 56043161 - Clean Track
®
L24
Introduction
This manual will help you get the most from your Clarke machine. Read it thoroughly before servicing the machine.
Note: Bold numbers and letters in parentheses indicate items illustrated in the Know Your Machine section.
Parts and Service
Repairs should be performed by your Authorized Clarke Center, that employs factory trained service personnel and
maintains an inventory of original replacement parts and accessories.
Call the Clarke Dealer named below for repair parts or service. Please specify the Model Number (same as the Part
Number) and Serial Number when discussing your machine.
(Dealer, afx service sticker here.)
Nameplate
The Part (Model) Number and Serial Number of your machine are
shown on the Nameplate located in the battery compartment. This
information is needed when ordering repair parts for the machine.
Use the space below to note the Part (Model) Number and Serial
Number of your machine for future reference.
Part Number
Serial Number
Transporting the Machine
Caution!
Before transporting the machine on an open truck or trailer, make sure that:
• The machine is tied down securely.
• All access doors and covers are secured (tape and strap as needed).
Towing
Caution!
If the machine must be towed or pushed, make sure the Master On/Off Key Switch (A) is in the Off position and do not
move the machine faster than a normal walking pace (2-3 mph, 3-5 kph) and for short distances only.
Note: Disconnecting the wheel drive motor wiring connector will make a disabled machine easier to push.
To Next Page
Loading...
Need help?
General
