52 - Form No. 56043161 - Clean Track
®
L24
Drive Motor Transaxle Removal (continued)
1. See Figure 20. Jack the front of the machine from this location until the drive wheels are approximately 1” off the
ground.
2. Remove the eight Locknuts (A) and then remove the two Drive Wheels (B) from the transaxle.
3. Disconnect the drive motor wiring connector.
4. Remove the four Motor Mount Bolts and Nuts (C) and carefully slide the Motor Transaxle (D) away from the
machine.
5. Reinstall the transaxle by following the above steps in reverse order.
Figure 20
To Next Page
Loading...
Need help?
General
