Clarke Clean Track® L24 56317170 User Manual

74 - Form No. 56043161 - Clean Track
®
L24
To Run the Wheel Drive Motor
The Drive Paddle (20) controls the wheel drive motor in the Service Test Mode.
• WiththeDrivePaddleintheneutralposition,themachinewillremainstationary.ThedisplaywillreadSPD:OFF.
• Pressing the Drive Paddle forward will move the machine forward. The display will read SPD:FOR.
• Pulling the Drive Paddle backward will move the machine in reverse. The display will read SPD:REV.
Indicator Function
SPD:OFF Machine is stationary
SPD:REV Machine traveling in reverse
SPD:FWD Machine traveling in forward
To Switch the Solution System On and Off
The Solution/Pre-spray Switch (C) controls the solution pump and solenoids in the Service Test Mode.
•
PressingtheSolution/Pre-spraySwitchthersttimeswitchesonthesolutionpumpandthesolenoidcontrollingthe
rear nozzle. The display will read SOL:1.
• Pressing the Solution/Pre-spray Switch the second time switches off the solution pump and the solenoid controlling
the rear nozzle. The display will read SOL:OFF.
• Pressing the Solution/Pre-spray Switch the third time switches on the solution pump and the solenoid controlling the
front nozzle. The display will read SOL:2.
• Pressing the Solution/Pre-spray Switch the fourth time switches off the solution pump and the solenoid controlling the
front nozzle. The display will read SOL:OFF.
Indicator Function
SOL:OFF Solution pump and solenoid valves are off
SOL:1 Solution pump and solenoid valve controlling rear (maintenance) nozzle are active.
SOL:2 Solution pump and solenoid valve controlling front (restoration) nozzle are active
To Lower and Raise the Scrub Deck
The Scrub ON Switch (J) controls the deck actuator in the Service Test Mode.
•
PressingtheScrubONSwitchthersttimewiththedeckupwillnotmovethedeck.Thedisplaywillcontinuetoread
ACT:OFF.
• Pressing the Scrub ON Switch a second time will start the actuator motor and move the deck downward. The display
will read ACT:DN.Whenthedeckreachesitsfull-downposition,theactuatormotorwillstopandthedisplaywillread
ACT:OFF.
• Pressing the Scrub ON Switch a third time with the deck down will not move the deck. The display will continue to
read ACT:OFF.
• Pressing the Scrub ON Switch a fourth time will start the actuator motor and lift the deck upward. The display will
read ACT:UP.Whenthedeckreachesitsfull-upposition,theactuatormotorwillstopandthedisplaywillread
ACT:OFF.
Indicator Function
ACT:OFF Scrub deck actuator is not moving
ACT:DWN Scrub deck actuator is lowering
ACT:UP Scrub deck actuator is rising

Clarke Clean Track® L24 56317170 Specifications

General

Brand	Clarke
Model	Clean Track® L24 56317170
Category	Floor Machine
Language	English